Challenger SRT-8 V8-6.1L (2009)
CAUTION: In following step, use care not to damage ball joint seal boot while sliding Ball Joint Remover 9360, into place past seal boot.
16. Using Ball Joint Remover 9360 (1), separate ball joint stud (2) from lower control arm.
17. Remove nut (5) from end of ball joint stud attaching lower control arm to knuckle.
18. Remove knuckle from vehicle.
19. If hub and bearing needs to be removed, perform the following:
a. Remove dust cap (2). When doing this, avoid damaging internal bore of hub to preserve seal integrity.
b. Remove hub nut (1).
