Challenger SRT-8 V8-6.1L (2009)
CAUTION: In following step, use care not to damage ball joint seal boot while sliding Ball Joint Remover 9360, into place past seal boot.
10. Using Puller 9360 (2), separate upper ball joint stud (1) from knuckle.
11. Remove nut (4) from end of upper ball joint stud (1).
12. Pull shock assembly (3) downward until studs clear shock tower (2), then pull it outward allowing access to upper control arm mounting bolts.
13. Remove upper control arm mounting (flag) bolts (1).
14. Remove upper control arm (2) from bracket (3) in shock tower (4).
Front Upper Control Arm - Installation
