Challenger SRT-8 V8-6.1L (2009)
6. Before starting the 9038 trans cooler cleaner (TCC), check the filter screen (2) for any debris. If debris is present, clean the filter screen in a parts
washer and dry completely.
CAUTION: FILTER SCREEN (2) MUST BE COMPLETELY CLEAN AND DRY BEFORE PROCEEDING. FAILURE TO COMPLY
COULD RESULT IN POSSIBLE CONTAMINATION AND DAMAGE TO THE COOLING SYSTEM.
7. Connect a compressed air line (90 to 120 psi recommended) to the air inlet fitting located on the rear of the 9038 trans cooler cleaner (TCC).
8. Power up and pre-heat the 9038 trans cooler cleaner (TCC) machine to 190°F (will take approximately 45 minutes with a full tank of fluid).
9. Refer to the 9038 transmission cooler cleaner's (TCC) owners manual and quick reference card for detailed operating instructions.
NOTE: It is recommended to flush/clean the system in 30 minute intervals.
TRANSMISSION OIL COOLER CLEANING
NOTE: Always start the cleaning procedure by reverse flushing the system first.
WARNING: WEAR PROTECTIVE EYE-WEAR AND APPROPRIATE HEAT RESISTANT GLOVES WHEN PERFORMING THIS
PROCEDURE.
NOTE: Refer to the Transmission Cooler Cleaner's operating instructions before starting this procedure.
1. With the transmission removed from the vehicle. Use tool 9038-1, trans cooler cleaner adapter kit (TCCAK) (1), to select the proper
adapter/fitting for the vehicle you are performing the procedure on.
