Challenger SRT-8 V8-6.1L (2009)
Seals and Gaskets: Service and Repair
Axle Shaft Seal - Installation
INSTALLATION
1. Using Installer 9919 (2) and Handle C-4171 (3), install NEW axle shaft seal (1). Lubricate the inside diameter with Mopar(R) Gear and Axle
Lubricant 75W-90 to protect seal during halfshaft installation.
2. Install halfshaft(s). See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Half Shaft - Installation
3. Remove fill plug (2) to check and adjust rear axle fluid level. Top off axle with Mopar(R) Gear and Axle Lubricant 75W-90. Reinstall fill plug and
torque to 35 Nm (25 ft. lbs.) torque.
