Charger L4-135 2.2L SOHC VIN C 2-bbl (1983)
Engine Block Heater: Technical Service Bulletins
Engine - Block Heater Installation
Models
All Car & Truck Equipped With 2.2L Engine
Subject
Engine Block Heater Installation
Index
ENGINE
Date
January 24, 1983
No.
09-01-83
P-51-C
Engine block heaters are a popular dealer installed accessory. Some questions have been asked by dealers regarding the correct installation procedures in
the 2.2L engine. Use the following procedures for correct installation.
1.
Drain the coolant from the radiator and the block.
2.
Using a long screwdriver or punch, knock the center rear core hole plug sideways.. Use pliers to remove the plug.
CAUTION: Do not leave the core plug in the water jacket if it should inadvertently fall into the jacket. If left in the jacket, the plug may restrict
coolant and result in engine overheating.
3.
Clean the machined hole to remove burrs, adhesive, etc.
4.
Loosen the screw on the heater element by hand to its limit.
5.
Lubricate the O-ring with Mopar Lubriplate or similar lubricant.
FIGURE 1 - INSTALL BLOCK HEATER IN CENTER REAR CORE PLUG OF BLOCK
6.
Carefully install the heater in the block with the element in the 10:30 position (Figure 1). Tighten the screw to 14-19 inch pounds.