Charger V6-2.7L (2008)
8. Pull the trim panel (1) away from the inside of the door shell far enough to access and disconnect the door wire harness (4) connectors from the
power window/lock/mirror switches (2), the door module (6), and the door courtesy lamp (5) as the vehicle is equipped.
9. Disengage the retainers (3) that secure the door wire harness to the inside of the trim panel.
10. Remove the trim panel from the inside of the door.
11. Remove door module if necessary. The heat stakes have to be cut off or drilled out. See: Locks/Door Locks/Door Module/Service and
Repair/Removal.
NOTE: A battery reconnect procedure must be performed anytime the battery has been disconnected. See: Starting and
Charging/Battery/Service and Repair/Procedures/Battery Reconnection.
Front Door Trim Panel - Installation
INSTALLATION
1. Check to be certain that the five spring nuts (1 and 3) are properly installed and in good condition on the inside of the door (2).
