Charger V6-2.7L (2008)
Sunroof / Moonroof Motor: Removal and Replacement
Sunroof Motor With Control Unit - Removal
REMOVAL
WARNING: The Excessive Force Limitation (EFL) feature must be calibrated any time a sunroof motor/module is replaced with a new
component. Failure to perform this procedure could result in vehicle damage and/or personal injury. See: Testing and Inspection/Programming
and Relearning/Excessive Force Limitation (EFL) Calibration for the appropriate procedure.
1. Disconnect the battery negative cable.
2. Remove the vehicle headliner, See: Interior Moulding / Trim/Headliner/Service and Repair/Headliner - Removal.
3. Remove the power sunroof motor/module electrical connector (2).
4. Remove the retaining screws (3) and remove the motor/module (1) from the vehicle.
Sunroof Motor With Control Unit - Installation
INSTALLATION
WARNING: The Excessive Force Limitation (EFL) feature must be calibrated any time a sunroof motor/module is replaced with a new
component. Failure to perform this procedure could result in vehicle damage and/or personal injury. See: Testing and Inspection/Programming
and Relearning/Excessive Force Limitation (EFL) Calibration for the appropriate procedure.
1. Position the power sunroof motor/module (1) in the vehicle.
2. Install the motor/module retaining screws (3). Tighten the screws to 4 Nm (35 in. lbs.).
3. Connect the motor/module electrical connector (2).
4. Connect the battery negative cable and move the sunroof through one open and close cycle to confirm proper system operation.
5. Install the vehicle headliner, See: Interior Moulding / Trim/Headliner/Service and Repair/Headliner - Installation.
6. Perform the sunroof position calibration, See: Testing and Inspection/Programming and Relearning/Sunroof Position Calibration.
