Charger V6-2.7L (2008)
Seat Heater: Description and Operation
Heated Seats - Description
Front
DESCRIPTION
WARNING: The front passenger seat assembly contains critical components that affect the front passenger airbag deployment. Correctly
functioning front passenger seat components are critical for the Occupant Classification System (OCS) to properly classify the front passenger
and calculate the proper airbag deployment. Unapproved modifications or service procedures to the front passenger seat assembly, its related
components, or trim cover may inadvertently change the airbag deployment in case of a frontal crash. This could result in death or serious
injury to the front seat passenger if the vehicle is involved in an accident. The following requirements must be strictly adhered to:
-
Do not modify the front passenger seat assembly or components in any way.
-
Do not modify the front seat center console or center position seat in any way.
-
Do not use prior or future model year seat trim covers not designated for the specific model being repaired. Always use the correct seat
trim cover specified for the vehicle.
-
Do not replace the seat trim cover with an aftermarket trim cover.
-
Do not add a secondary trim cover other than those approved by DaimlerChrysler/Mopar.
-
At no time should any Supplemental Restraint System (SRS) component or SRS related component or fastener be modified or replaced
with any part except those which are approved by DaimlerChrysler/Mopar.
Vehicles with the heated seat option can be visually identified by the two heated seat switches (1) located in the center stack of the instrument panel. The
heated seat system allows the driver and front seat passenger to select from two different levels of electrical seat heating (HI/LO). The heated seat system
for this vehicle includes the following major components, which are described in further detail later:
-
Heated Seat Elements - Four heated seat elements are used per vehicle. Two heated seat elements are integral to each seat, one in the seat back
and the other in the seat cushion.
-
Heated Seat Module - One heated seat module is used per vehicle. The Heated Seat Module is mounted under the right front seat. This module
contains the control logic and software for the front heated seat system. The module communicates on the Controller Area Network (CAN) data
bus.
-
Heated Seat Switches - Two heated seat switches are used per vehicle, one for each heated seat. Both switches are mounted in the instrument
panel center stack.
-
Instrument Cluster (CCN) - A Cab Compartment Node (CCN) is part of the instrument cluster on this vehicle. The CCN utilizes integrated
software and information carried on the CAN data bus. The CCN serves as the link between the heated seat switches and the heated seat module.
Rear
DESCRIPTION
