Charger V6-2.7L (2008)
1. Remove the heated seat switch/modules from the center floor console, See: Seat Heater Switch/Service and Repair/Heated Seat Switch - Removal.
2. Connect the battery negative cable.
3. Turn the ignition to the "RUN" position.
4. Check for battery voltage on terminals 4 and 6 of the switch/module connector of the inoperative seat. Battery voltage should be present on both
terminals. If OK go to STEP 5. If NOT OK repair the open or shorted fused B(+) circuit as required.
5. Check for continuity between ground terminal 1 of the switch/module connector of the inoperative seat and a good ground. If OK go to STEP 6. If
NOT OK, repair the open or shorted ground circuit as required.
6. Check for continuity between the heated rear seat element supply circuit terminal 3 of the switch/module connector of the inoperative seat and the
heated rear seat element connector of the inoperative seat. If OK go to STEP 7. If NOT OK, repair the open or shorted supply circuit as required.
7. Perform the heated rear seat element diagnosis for the inoperative seat. See: Heated Seat Element - Diagnosis and Testing to check the suspect
heated rear seat elements. If the elements test OK, replace the inoperative heated seat switch/module, See: Seat Heater Switch/Service and
Repair/Heated Seat Switch - Removal for the appropriate procedure. If NOT OK, replace the inoperative heated rear seat element, See: Service
and Repair/Heated Seat Element - Removal for the appropriate procedure.
RIGHT REAR HEATED SEAT SWITCH/MODULE
8. Remove the heated seat switch/modules from the center floor console, See: Seat Heater Switch/Service and Repair/Heated Seat Switch - Removal.
9. Connect the battery negative cable.
10. Turn the ignition to the "RUN" position.
11. Check for battery voltage on terminals 4 and 6 of the switch/module connector of the inoperative seat. Battery voltage should be present on both
terminals. If OK go to STEP 5. If NOT OK repair the open or shorted fused B(+) circuit as required.
12. Check for continuity between ground terminal 1 of the switch/module connector of the inoperative seat and a good ground. If OK go to STEP 6. If
NOT OK, repair the open or shorted ground circuit as required.
13. Check for continuity between the heated rear seat element supply circuit terminal 3 of the switch/module connector of the inoperative seat and the
heated rear seat element connector of the inoperative seat. If OK go to STEP 7. If NOT OK, repair the open or shorted supply circuit as required.
14. Perform the heated rear seat element diagnosis for the inoperative seat. See: Heated Seat Element - Diagnosis and Testing to check the suspect
heated rear seat elements. If the elements test OK, replace the inoperative heated seat switch/module, See: Seat Heater Switch/Service and
Repair/Heated Seat Switch - Removal for the appropriate procedure. If NOT OK, replace the inoperative heated rear seat element, See: Service
and Repair/Heated Seat Element - Removal for the appropriate procedure.
