Charger V6-2.7L (2008)
Seat Heater Switch: Service and Repair
Heated Seat Switch - Installation
Front Seats
INSTALLATION
1. From the front of the ash receiver (1), gently push the heated seat switch (3) in through the front of the bezel.
2. Connect the heated seat switch connector (2) onto the heated seat switch (3).
3. Install the ash receiver (1) into the instrument panel, See: Interior Moulding / Trim/Ash Tray/Service and Repair/Installation.
4. Connect the battery negative cable.
5. Verify heated seat system operation.
Rear Seats
INSTALLATION
1. Align the tabs (1) of the switch/module (2) to the bezel and gently push together until the tabs are securely in place.