Charger V6-2.7L (2008)
3. Place trim stick (4) between brake pad (2) and outer edge of rotor (3).
4. Using trim stick, slowly apply pressure against brake pad (2) until both pistons (on that side of caliper) are completely bottomed in bores of caliper
half.
NOTE: Repeat above procedure to opposite brake pad (1) and pistons as necessary.
5. Remove caliper mounting bolts (1).
6. Remove brake caliper (2) with pads from knuckle (8) and brake rotor (3). Hang assembly out of way using wire or a bungee cord. Use care not to
overextend brake hose when doing this.
7. Remove any clips (4) retaining brake rotor (3) to wheel studs.
8. Slide brake rotor (3) off hub and bearing (7).
Rear - SRT8
REAR - SRT8
NOTE: Before proceeding, See: Service Precautions/Brakes - Caution.
1. Raise and support vehicle. See: Maintenance/Vehicle Lifting/Service and Repair