Charger V6-2.7L (2008)
7. Install tire and wheel assembly (1) See: Maintenance/Wheels and Tires/Service and Repair/Removal and Replacement/Tires and Wheels -
Installation. Tighten wheel mounting nuts (3) to 150 Nm (110 ft. lbs.) (Police - 190 Nm (140 ft. lbs.)).
8. Lower vehicle.
9. Pump brake pedal several times to ensure vehicle has a firm brake pedal before moving vehicle.
10. Check and adjust brake fluid level in reservoir (1) as necessary.
CAUTION: If NEW brake rotors or pads have been installed, keep in mind that braking effectiveness might be somewhat reduced during
the first brake applications following installation.
CAUTION: A burnish procedure must be performed anytime NEW brake pads or rotors are installed on a vehicle equipped with the Police
Package. This procedure is particularly important in situations where high speed pursuit is a possibility. It is recommended that the procedure
be performed by the Police agency operating the vehicle so it can be performed in a safe controlled environment. This information is covered in
the Police Package Owners Manual Supplement which was supplied when the vehicle was originally delivered.
11. Road test vehicle making several stops to wear off any foreign material on brakes and to seat brake shoes. If the vehicle is equipped with the
Police Package, a burnish procedure must be followed (Refer to preceding Caution).
Rear
REAR
NOTE: Inspect disc brake pads and parking brake shoes before installation. See: Brake Pad/Service and Repair/Procedures/Brake Pads - Inspection
