Charger V6-2.7L (2008)
5. Remove cylinder head coversSee: Valve Cover/Service and Repair/Cylinder Head Cover - Removal.
6. Remove crankshaft vibration damperSee: Cylinder Block Assembly/Harmonic Balancer - Crankshaft Pulley/Service and Repair/Vibration Damper
- Removal.
7. Remove timing chain coverSee: Timing Components/Timing Cover/Service and Repair/Timing Cover - Removal.
8. Remove timing chainSee: Timing Components/Timing Chain/Service and Repair/Timing Chain & Sprockets - Removal.
9. Remove camshafts and rocker armsSee: Camshaft, Lifters and Push Rods/Camshaft/Service and Repair/Removal and Replacement/Camshaft -
Removal.
10. With air hose attached to spark plug adapter installed in the cylinder being serviced, apply 620.5-689 kPa (90-100 psi) air pressure. This is to hold
valves in place while servicing components.
11. Using Special Tool MD 998772A with adapter 6779, compress valve spring and remove valve locks, retainer, and valve spring.
12. Remove valve stem seal See: Seals and Gaskets/Valve Guide Seal/Service and Repair/Valve Guide Seals - Removal.
Off Vehicle
OFF VEHICLE
1. With cylinder head removed, compress valve springs (3) using a Special Tool C-3422-D, Valve Spring Compressor.
2. Remove valve retaining locks (1), valve spring retainers (2), valve springs (3).
In Vehicle
IN VEHICLE
