Charger V6-2.7L (2008)
NOTE: The EGR tube flange (1) does not need to be flush with the intake manifold (2) to be sealed. The EGR tube flange can be up to 2 mm (0.08 in.)
from intake manifold and still be sealed. This design allows the EGR tube position to vary with the tolerance stack up and remain properly sealed.
11. Connect electrical connectors to the following components:
-
Manifold Absolute Pressure (MAP) Sensor
-
Electronic Throttle Control
-
Manifold Tuning Valve
12. Install throttle body air inlet hose and air cleaner housing assembly.
13. Connect negative battery cable and tighten nut to 5 Nm (45 in. lbs.).
