Charger V6-2.7L (2008)
9. Connect negative battery (1) cable.
Right
RIGHT EXHAUST MANIFOLD
1. Install exhaust manifold gasket and manifold (4). Tighten bolts working from center outwards to 23 Nm (200 in. lbs.).
2. Install exhaust pipe to manifoldSee: Catalytic Converter/Service and Repair/Removal and Replacement/Catalytic Converter - Installation.
3. Install lower heat shield (3) and upper heat shield (2).
4. Install oxygen sensor (5) and connect electrical connector.
5. Connect down stream oxygen sensor electrical connector.
6. Lower vehicle.
7. Install EGR tube (1) using new gaskets. Tighten screws to 11 Nm (95 in. lbs.).