Charger V6-2.7L (2008)
6. Remove upper tube bolts to EGR valve (2).
7. Remove upper tube from intake manifold.
NOTE: Replace the EGR tube gasket and silicone rubber seals any time the EGR tube is removed from the intake manifold.
8. When removing EGR upper tube assembly being careful not to drop the silicone rubber seals in the intake manifold. Clean gasket surfaces on the
EGR valve. Note that any loose dirt can lodge between the pintle and the seat and cause valve leakage that will give a rough idle and depressed
manifold vacuum.
9. Clean mounting surface.
Installation
CAUTION: Do Not use metal scrapers when cleaning the mounting surface of the EGR valve. Damage from scratching the surface may cause an
improper seal.
CAUTION: Do not allow debris to enter the EGR valve when cleaning the mounting surface. Debris can lodge between the pintle and the seat causing
valve leakage that results in rough idle and depressed manifold vacuum.
1. Clean and inspect gasket sealing surfaces.
NOTE: Install new rubber silicone seals on intake manifold end of EGR tube any time it is removed from the intake manifold.
