Charger V6-2.7L (2008)
Camshaft Position Sensor: Service and Repair
Camshaft Position Sensor - Installation
2.7L
CAUTION: Install camshaft position (CMP) sensor utilizing twisting motion. Make sure CMP sensor is fully seated. Do not drive CMP sensor
into the bore with mounting screw. This may cause CMP sensor to be incorrectly seated causing a faulty signal or no signal at all.
1. Install sensor and mounting bolt.
2. Tighten bolt to 12 Nm (106 in. lbs.).
3. Connect electrical connector and lock.
4. Connect negative battery cable and tighten to 5 Nm (45 in. lbs.).
