Charger V6-2.7L (2008)
1. Install wheel speed sensor head (4) into knuckle and install mounting screw (3). Tighten screw to 11 Nm (97 in. lbs.).
2. Attach wheel speed sensor cable and routing clip (2) to brake hose routing bracket (5).
3. Attach sensor cable routing clip (2) to brake hose bracket (3).
4. Connect sensor connector (1) to body wiring harness connector (4). When installing connector, make sure retaining clip on body connector is
properly in place and sensor connect cannot be pulled out.
5. Lower vehicle.
6. Perform Verification Test and clear any faults. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic
Trouble Code Tests and Associated Procedures/Verification Tests