Charger V6-2.7L (2008)
Cruise Control Switch: Service and Repair
Installation
Adaptive Cruise Control/Standard Passenger Speed Control Switch
ADAPTIVE CRUISE CONTROL/STANDARD PASSENGER SPEED CONTROL SWITCH
WARNING: The Adaptive Cruise Control Switch and Standard Passenger style Speed Control Switch are mounted identically, have
similarities in appearance but function differently. Make sure the vehicle is equipped with either the Standard Passenger style Speed Control
System or Adaptive Cruise Control System and ONLY replace with the correct switch during removal and installation procedures. If the
Standard Passenger style Speed Control Switch is used to replace an Adaptive Cruise Control switch, then the "Distance Function" of the
Adaptive Cruise Control System WILL NOT work, and the system will work as a Standard Speed Control equipped vehicle. The driver will not
know that the "Distance Function" of the Active Cruise Control System is not functioning and this could lead to personal and/or fatal injury.
1. Install speed control switch (2) to steering wheel.
2. Install rear screws (1) to speed control switch (2) and tighten to 1 Nm (9 in. lbs.).
3. Install front screw (1) to speed control switch (3) and tighten to 3.5 Nm (30 in. lbs.).
4. Connect electrical connector (2) to speed control switch (3).
5. Install steering wheel airbag, See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Driver Airbag - Installation.
6. Verify vehicle and system operation.
Police Package Speed Control Switch
POLICE PACKAGE SPEED CONTROL SWITCH
