Charger V6-2.7L (2008)
Power Steering Fluid Cooler: Service and Repair
Power Steering Fluid Cooler - Installation
Fluid Cooler
FLUID COOLER
1. Install cooler over mounting clips attached to cooling module. Push cooler past clip retaining tabs allowing it to lock into place.
NOTE: If a lengthwise paint stripe appears on the return hose (3) near the end, position that paint stripe at the top (12 O'clock position) when
installed on the cooler. This positioning must be done to ensure proper hose routing.
2. Slide return hose to reservoir (3) onto left end of cooler (2). Install clamp securing hose in place.
3. Slide return hose from gear (1) onto right end of cooler (2). Install clamp securing hose in place.
4. Install belly pan. See: Body and Frame/Exterior Moulding / Trim/Underbody Cover/Service and Repair/Belly Pan - Installation
5. Lower vehicle.
