Charger V6-2.7L (2008)
10. Install three nuts (2) fastening shock assembly (4) to shock tower (3). Tighten nuts to 27 Nm (20 ft. lbs.).
11. If equipped, align shock tower cap (1) with shock mounting nuts (2) and snap into place.
12. If installing left upper control arm, install coolant recovery container. See: Engine, Cooling and Exhaust/Cooling System/Coolant
Reservoir/Service and Repair/Coolant Recovery Container - Installation
13. If installing right upper control arm, install IPM. See: Power and Ground Distribution/Power Distribution Module/Service and Repair/Installation
