Charger V6-2.7L (2008)
2. Remove wheel mounting nuts (3), then rear tire and wheel assembly (1).
3. Remove bolt and nut (2) mounting link (3) at knuckle.
4. Remove bolt and nut (1) mounting link (3) at crossmember.
5. Remove link (3).
Installation
INSTALLATION
NOTE: Although the compression link is different end-to-end, there is no top and bottom.
1. Position link and install bolt and nut (1) mounting link (3) at crossmember. Do not tighten bolt at this time.
2. Install bolt and nut (2) mounting link (3) at knuckle. Do not tighten bolt at this time.
