Charger V6-2.7L (2008)
NOTE: When installing tension link, although link (6) is same end-to-end, make sure that center bow is facing downward.
1. Place link in bracket on crossmember (1). Install bolt and nut (4) at crossmember (1) as shown. Do not tighten bolt at this time.
2. Install bolt and nut (4) mounting link to knuckle (3) as shown. Do not tighten bolt at this time.
3. Install shock absorber (3) by setting lower end into pocket in spring link (4), then tipping top inward until aligned with upper mounting holes.
