Charger V6-2.7L (2008)
Transmission Cooler: Service and Repair
Thermo Bypass Valve
Removal
REMOVAL
1. Raise and support vehicle.
2. Remove front transmission cooler lines from the thermal bypass valve block (2).
3. Remove rear transmission cooler lines from the thermal bypass valve block (2).
4. Remove thermal bypass valve block (2).
Installation
INSTALLATION
1. Position thermal bypass valve. Install mounting bolt. Tighten mounting bolt to: 2.7L/5.7L/6.1L engine 50 Nm (37 ft. lbs.), 3.0L/3.5L engine 26
Nm (19 ft.lbs.).
2. Install rear transmission cooler lines to thermal bypass valve. Tighten fittings to 20 Nm (18 ft. lbs.).
3. Install front transmission cooler lines to thermal bypass valve. Tighten fittings to 20 Nm (18 ft. lbs.).