Charger V6-2.7L (2008)
3. Install pinion flange into position. Align index marks to maintain assembly balance.
4. Using Installer 6448A (1), lightly tap on pinion flange (2) until adequate pinion shaft threads are exposed.
5. Install new pinion flange nut. Using Flange Wrench C-3281 (1) and 41mm socket, torque nut to 136 Nm (100 ft. lbs.).
6. Measure assembly turning torque. Axle assembly rotating torque must be should be equal to the reading recorded upon seal/flange removal.
