Charger V6-2.7L (2008)
7. If rotating torque is low, increase pinion flange nut torque in 7 Nm (5 ft. lbs.) increments. Repeat until proper rotating torque is received.
8. Stake pinion flange nut (1) as shown.
9. Install rear axle assembly. Refer to Rear Axle Installation.
Removal
REMOVAL
1. Remove halfshaft(s).See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Half Shaft - Removal
2. Using suitable screwdriver (1), remove axle shaft seal (2).
3. Visually inspect halfshaft seal journal for damage (excessive seal groove, nicks, scratches, etc.). Replace halfshaft if necessary.
Installation