Charger V6-2.7L VIN T (2007)
3. Installing a new door trim panel (1) with the original door module (6) or new door module (6) the module can be attached by using screws or heat
stake the door module (6) to the trim panel. If the door module (6) was removed or being replaced, use screws to attach door module (6) to the
second set of bosses on the door trim panel (1). If the door module (6) was removed or being replaced, use screws to attach module to the second
set of bosses on the door trim panel (1).
4. Position the trim panel (1) close enough to the inside of the door to engage the retainers (3) that secure the door wire harness (4) to the inside of
the trim panel.
5. Reconnect the door wire harness connectors to the power window/lock/mirror switches (2), the door module (6), and the door courtesy lamp (5) as
the vehicle is equipped.
6. Reach between the top of the trim panel (3) and the inside of the door shell to engage the end of the interior door handle latch release link (1) to
the handle lever (2) and snap the plastic clip over the link to secure it to the handle.
7. Lift the trim panel (2) over the inside of the door far enough to engage the interior door latch lock link and knob (1) into the clearance hole at the
upper rear corner of the panel.
