Charger V6-2.7L VIN T (2007)
CAUTION: Do not allow the watershield or adhesive to become contaminated with dirt or other foreign substances.
Do not damage the watershield during removal and installation.
If the watershield becomes contaminated or damaged, replace the watershield.
1. Thread the inside latch lock knob and link through the slit near the upper rear corner of the watershield (2).
2. Thread the inside remote latch release handle link through the slit in the upper center area of the watershield.
3. Place the front and rear dimple formations located in the upper watershield into their respective locator holes in the door (1) inner panel.
4. Apply firm and even pressure to the adhesive bead along the upper edge of the watershield to seal it to the inside of the door.
5. Lift the lower half of the watershield upward far enough to access and pull the trim panel take out of the door wire harness out of through the slit
near the front of the watershield.
6. Apply firm and even pressure to the adhesive bead along the remaining edges of the watershield to seal it to the inside of the door. Be certain that
the watershield is sealed to the inside of the door.
7. Reinstall the trim panel onto the inside of the rear door.
