Charger V6-2.7L VIN T (2007)
33. For each parking brake cable, place 13 mm 12-point box wrench (4) over cable strand and completely onto cable retainer (3) as shown at
crossmember bracket (1 - left)(2 - right). It may be necessary to wiggle wrench around somewhat to collapse retainer fingers. With wrench in
place, pull cable from bracket.
34. On each side, remove screw fastening parking brake cable routing guide (1) to crossmember. Remove J-nuts from crossmember.
NOTE: For installation purposes, when removing fasteners for any rear suspension links, it is important to note which bolt fastens what
component and in what direction it is installed in.
35. On each side of crossmember, remove bolt and nut (1) fastening spring link (4) to crossmember.
