Charger V6-2.7L VIN T (2007)
5. Position the seat belt (4) and turning loop to the height adjuster on the upper B-pillar (2). Be certain that the webbing is not twisted.
6. Install and tighten the screw (1) that secures the turning loop to the seat belt height adjuster on the upper B-pillar. Tighten the screw to 40 Nm (30
ft. lbs.).
7. Position the trim cover (3) over the seat belt turning loop on the inside of the upper B-pillar.
8. Using hand pressure, press the trim cover and turning loop together until the cover snaps into place.
9. Reinstall the lower trim onto the inside of the B-pillar.
Lower
LOWER
1. Remove the rear seat cushion from the vehicle.
2. Remove the rear seat back side bolster from the quarter inner panel (1).
3. Remove the screw (4) that secures the upper end of the lower C-pillar trim (5) to the rear shelf panel (3).
4. Remove the two screws that secure the lower C-pillar trim to the quarter inner panel.
5. Remove the lower C-pillar trim from the quarter inner panel.
Upper-Sedan
UPPER - SEDAN
