Charger V6-2.7L VIN T (2007)
SRT8 vehicles have the minimum thickness specification stamped into the outer diameter edge (1) (along vented end) of the disc.
ROTOR THICKNESS VARIATION
Thickness variation in a rotor's braking surface can result in pedal pulsation, chatter and surge. This can also be caused by excessive runout in the rotor
or the hub.
Rotor thickness variation measurements should be made in conjunction with measuring runout. Measure thickness of the brake rotor (2) at 12 equal
points around the rotor braking surface with a micrometer (1) at a radius approximately 25 mm (1 inch) from edge of rotor. If thickness measurements
vary beyond the specification listed in the specification table.
ROTOR RUNOUT
