Charger V6-2.7L VIN T (2007)
Vacuum Brake Booster: Service and Repair
Removal
BOOSTER
1. Move driver's seat to full rearward position.
2. Disconnect and isolate battery negative cable (2) from battery post.
3. Remove windshield wiper module.
4. Remove master cylinder.
5. If equipped with MK25 and Electronic Stability Program (ESP), disconnect wiring harness (6) connector at pedal travel sensor (7) on power brake
booster (3).
6. If equipped with MK25 and ESP, disconnect wiring harness (6) connector at active brake booster solenoid (4).