Charger V6-2.7L VIN T (2007)
6. Lift ICU (1) from mounting grommets (2) and move inboard allowing access to ABM attaching screws. Do not force brake tubes. Move assembly
just enough to access mounting screws.
7. Remove four screws (1) attaching ABM (2) to HCU.
8. Slide ABM (1) off HCU (2).
Installation
INSTALLATION
1. Clean any debris off the mating surfaces of the HCU and ABM.
CAUTION: When installing new O-rings or solenoid valve stem seals, do not use any type of lubricant.
