Charger V6-2.7L VIN T (2007)
NOTE: Upper and lower bearing halves are NOT interchangeable.
CAUTION: Main bearings are select fit.
1. Install the main bearing in the block and main caps making sure the tangs engage the slots in the block and main caps.
2. Lubricate upper main bearing halves with engine oil.
CAUTION: When installing crankshaft, use care not to damage bearing surfaces on the crankshaft.
3. Install crankshaft.
NOTE: Make sure that the coated and oil groove side of crankshaft thrust washer faces the crankshaft thrust surface.
4. Push crankshaft forward. Lubricate and install the front thrust washer (1) by rolling the thrust washer onto the machined shelf between the No. 3
upper main bulk head and crankshaft thrust surface.
5. Move crankshaft rearward. Lubricate and install the rear thrust washer by rolling the thrust washer onto the machined shelf between the No. 3
upper main bulk head and crankshaft thrust surface.
