Charger V6-2.7L VIN T (2007)
1. Position the fresh air inlet housing (4) and water separator (2) or particulate air filter (6) and filter housing (5) (depending on application) as an
assembly onto the engine compartment side of the dash panel (3).
2. Install the two nuts (1) that secure the fresh air inlet housing and water separator or filter housing (depending on application) to the dash panel.
Tighten the nuts to 7 Nm (62 in. lbs.).
3. Position the insulator (4) into its installed location and install the push-pin retainer (5) that secures the insulator to the front of the fresh air inlet
housing (2).
4. Install the push-pin retainer (1) that secures the fresh air inlet housing to the right inner fender (6).
5. Reach under the fresh air inlet housing and install the wire harness retainer (3) into the bottom of the air inlet housing, if equipped.
6. Position the powertrain control module (PCM) or the engine control module (ECM) (2) (depending on engine application) into its installed
