Charger V6-2.7L VIN T (2007)
12. Connect battery negative cable (2) to battery post. It is important that this is performed properly.
13. Fill and bleed power steering system.
14. Perform wheel alignment setting toe to specifications.
15. Tighten tie rod jam nuts (1) to 75 Nm (55 ft. lbs.).
Rear-Wheel-Drive
REAR-WHEEL-DRIVE
1. If necessary, install outer tie rods from original gear to replacement inner tie rods. Install each outer tie rod same amount of threads as it was
installed on original gear. This will get toe setting close, saving some time when toe is set later in this procedure.
2. Lift steering gear (2) into mounted position and install steering gear mounting bolts (1). Tighten bolts to 95 Nm (70 ft. lbs.).
