Charger V6-2.7L VIN T (2007)
3. Install shock absorber (3) by setting lower end into pocket in spring link (4), then tipping top inward until aligned with upper mounting holes.
4. Install lower shock mounting bolt and nut. Do not tighten at this time.
5. If vehicle is equipped with AWD, make sure spacers (1) on top of crossmember mount bushings (2) on side of repair are in position.
6. Carefully raise jack, guiding coil spring and upper end of shock absorber (4) into mounted positions.
7. Install shock absorber upper mounting screws (2). Tighten upper mounting screws to 52 Nm (38 ft. lbs.).
