Charger V6-2.7L VIN T (2007)
50. Install J-nut for mounting parking brake cable routing bracket to crossmember.
51. Insert front parking brake cable routing bracket locating pin into front flange of crossmember (3), then install screw (2) fastening cable (1) routing
bracket to rear crossmember.
52. On each side of vehicle, slide an axle half shaft (2) through hub and bearing and install hub nut (1). Do not tighten hub nuts at this time.
53. Install rear axle differential.
54. While a helper applies brakes to keep hub from turning, tighten hub nut to 213 Nm (157 ft. lbs.).