Charger V6-2.7L VIN T (2007)
5. Slide cam bolt (2) rearward out of crossmember and link (1).
6. Remove mounting bolt (3) and nut at knuckle.
7. Remove toe link (1).
Left Link
LEFT LINK
1. Slide crossmember end of toe link (1) into box bracket on crossmember. Slide cam bolt (2) through bracket and link from rear.
2. Install bolt (3) and nut securing link to knuckle. Do not tighten bolt at this time.
3. While holding toe adjustment cam bolt from rotating (cam facing upward), Install cam washer (2) and nut (3) securing toe link at crossmember (1).
Do not tighten nut at this time.