Charger V6-2.7L VIN T (2007)
CAUTION: In following step, use care not to damage ball joint seal boot while sliding Puller, Special Tool 9360, into place past seal boot.
9. Using Puller (2), Special Tool 9360, separate upper ball joint stud (1) from knuckle.
10. Remove nut (4) from end of upper ball joint stud (1).
11. Tip top of knuckle outward using care not to overextend bake flex hose.
12. Remove shock assembly from vehicle.
All-Wheel-Drive
ALL-WHEEL-DRIVE
1. Guide shock assembly up into shock tower (3) and into mounting holes.
