Charger V6-2.7L VIN T (2007)
4. Remove the spider assembly (1) from interconnecting shaft (4). If spider assembly will not come off interconnecting shaft by hand, it can be
removed by tapping spider assembly with a brass drift (3).
5. Slide sealing boot off interconnecting shaft.
6. Thoroughly clean and inspect spider assembly, tripod joint housing, and interconnecting shaft for any signs of excessive wear. If any parts show
signs of excessive wear, the driveshaft assembly will require replacement. Component parts of these driveshaft assemblies are not
serviceable.
Installation
INSTALLATION
1. Slide inner tripod joint seal boot retaining clamp, onto interconnecting shaft. Then, slide the replacement inner tripod joint sealing boot (1) onto
the interconnecting shaft. Inner tripod joint seal boot MUST be positioned on interconnecting shaft, so the raised bead on the inside of the
seal boot is in groove (3) on interconnecting shaft (4).
2. Install spider assembly (1) onto interconnecting shaft (2). Spider assembly must be installed on interconnecting shaft far enough to fully install
spider retaining snap ring.
3. If spider assembly (2) will not fully install on interconnecting shaft by hand, it can be installed by tapping the spider body with a brass drift (4). Do
not hit the outer tripod bearings in an attempt to install spider assembly on interconnecting shaft.
