Charger V6-2.7L VIN T (2007)
Seals and Gaskets: Service and Repair
Rear Axle - 198RII
Removal
REMOVAL
1. Remove halfshaft(s).
2. Using suitable screwdriver (1), remove axle shaft seal (2).
3. Visually inspect halfshaft seal journal for damage (excessive seal groove, nicks, scratches, etc.). Replace halfshaft if necessary.
Installation
INSTALLATION
1. Using Installer 9223 (2), install NEW axle shaft seal (1). Lubricate the inside diameter with Mopar(R) Gear and Axle Lubricant 75W-140 to
protect seal during halfshaft installation.
2. Install halfshaft(s).