Charger V6-3.5L (2009)
40. Install rear exhaust system (2) (dual-outlet exhaust shown in figure).
41. Install tire and wheel assemblies (1). Tighten wheel mounting nuts (3) to 150 Nm (110 ft. lbs.). See: Maintenance/Wheels and Tires/Service and
Repair/Removal and Replacement/Tires and Wheels - Installation
42. Lower vehicle until rear wheels are just above floor level.
43. Apply parking brake lever. Release lever, then reapply.
44. Check to make sure rear wheels will not rotate with lever applied.
45. Lower vehicle.
46. Connect battery negative cable (2) to battery post. It is important that this is performed properly. See: Starting and Charging/Battery/Service and
