Charger V6-3.5L (2009)
Door Module: Service and Repair
Door Module - Removal
REMOVAL
NOTE: A battery reconnect procedure must be performed anytime the battery has been disconnected. See: Starting and
Charging/Battery/Service and Repair/Procedures/Battery Reconnection .
1. Disconnect and isolate the battery negative cable.
2. Remove the trim panel from inside of the front door (1). See: Doors, Hood and Trunk/Doors/Front Door/Front Door Panel/Service and
Repair/Front Door Trim Panel - Removal.
3. Disconnect the door wire harness connections from the door control module (3) connector receptacles.
4. Disengage the two plastic push-in fasteners (2) that secure the module to the door inner panel.
5. Remove the door control module from the vehicle.