Charger V6-3.5L (2009)
Keyless Start Antenna: Service and Repair
Remote Start Antenna - Removal
REMOVAL
WARNING: Wait two minutes for the system reserve capacitor to discharge before servicing any airbag components. Failure to do this may
result in serious or fatal injury.
The remote start antenna is located on the passenger side above and to the left of glove box.
1. Disconnect and isolate the battery negative cable.
2. Remove screws from Wireless Ignition Node (WIN), See: Powertrain Management/Ignition System/Sensors and Switches - Ignition
System/Ignition Switch/Service and Repair/Wireless Ignition Node Receiver - Removal.
3. Remove the coaxial electrical cable connector (1) from WIN (2).
4. Remove center bezel, refer to See: Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel Bezel - Removal.
NOTE: During removal of the remote start antenna note the routing location of the coaxial cable.
5. Remove the remote start antenna coaxial cable from mounting clips, if equipped.
