Charger V6-3.5L (2009)
NOTE: Do not drive the adjuster track more than 12mm (1/2 in) in any one direction at one time before driving the other side to minimize
twist in the adjuster.
6. Install the short flex shaft into the seat track gear box.
7. Install the fore/aft motor with grommets on the short flex shaft side first, then install the long flex shaft into outboard side track gear box first then
slide flex shaft cover over long flex shaft and then insert in to motor.
8. Install the long flex shaft into the seat track and clip long flex shaft sheathing into the clips.
9. Connect electrical connector to the fore/aft motor.
10. Connect the battery.
NOTE: Make sure front and rear rail end stops, rail ends, and drive screws are free of foreign material before fully drive seat to the full rear
position.
11. Adjust the seat to the full rear position.
12. Disconnect the battery.
13. Remove the fore/aft motor and flex shafts from bracket.
14. Using cordless drill and flex shaft, verify that the tracks are all the way back and within +/- 1mm of each other.
NOTE: As you reach the end of the adjuster track travel slow down the speed so you do not over twist the flex shaft.
15. Remove fore/aft motor bracket bolts taking care to make sure no thread locker particles enter drive screws.
16. Inspect both ends of each drive screw for foreign material, and remove as necessary.
