Charger V6-3.5L (2009)
1. Install new fore/aft motor bracket and bolts 26 +/- 2 Nm ( 19 +/- 1.5 ft lbf).
2. Install new short flex shaft into gear box.
3. Install fore/aft motor into fore/aft motor bracket and short flex shaft.
4. Install new long flex shaft into gear box.
5. Slide new long flex shaft cover over long flex shaft.
6. Install long flex shaft into fore/aft motor.
7. Seat fore/aft motor into fore/aft motor bracket.
8. Install tie straps as shown in figure, making sure the tie strap goes under connector and cut off excess.
9. Install seat See: Service and Repair/Seat, Front/Seat - Installation
10. Install seat cover and cushion See: Seat Cover/Service and Repair/Seat Cushion Cover - Installation
NOTE: Make sure all electrical connectors are properly connected to seat pan.
11. Verify that the power seat is working correctly by running through the full travel, and that there is not excessive noise coming from the motor or
track.
