Charger V6-3.5L (2009)
1. Before proceeding with the following repair procedure, review all warnings and cautions. See: Service Precautions
WARNING: A seat structure that has seen significant load may have the locking mechanism activated and may exhibit the following symptoms:
-
Locking pawl (2) loose
-
Locking pawl (2) engaged into the seat frame side member (1)
-
Height adjuster only works on outboard side
-
Broken or missing shear pin (3)
If any one or more of these symptoms exist replace the height adjuster assembly. Do not attempt any repairs. Failure to follow these
instructions may result in personal injury or death.
2. Install the seat risers. See: Service and Repair/Seat Riser - Installation
3. Position the height adjuster assembly (1) onto the length adjuster assembly (3) and install the nuts, bolts and spacers on the inboard side.
NOTE: Bolts (2) and (4) are different and need to be installed into the correct positions.
4. Tighten the bolts to 21 Nm (15 ft. lbs.).
5. Install the seat cushion and install the seat. See: Seat Cover/Service and Repair/Seat Cushion Cover - Installation
Manual
