Charger V6-3.5L (2009)
1. Insert wheel speed sensor head (3) into mounting hole in rear of knuckle.
2. Install screw (2) fastening sensor head (3) to rear knuckle. Tighten Screw to 11 Nm (97 in. lbs.).
3. Install sensor cable at rear brake rotor shield (1).
4. Clip sensor cable (2) to routing clips (3) along toe link.
5. If installing left sensor, clip sensor cable (2) to routing clip (1) above toe link mount on rear crossmember.
6. If installing left sensor, clip sensor cable (1) to routing clips (2) along rear of crossmember near rear differential (3).
