Charger V6-3.5L (2009)
Twin Pistion
ASSEMBLY
CAUTION: Dirt, oil, and solvents can damage caliper seals. Ensure assembly area is clean and dry.
NOTE: Always use new, clean Mopar(R) DOT 3 Motor Vehicle Brake Fluid when assembling brake caliper.
NOTE: Never use old or used piston seals or boots for assembly.
1. Lubricate caliper pistons, piston seals (1) and piston bores (2) with clean, fresh brake fluid.
2. Install NEW piston seal (1) into groove of each caliper piston bore (2). NOTE: Make sure seal is fully seated and not twisted in groove.
3. Install NEW boot (1) on each piston (2) and work boot lip into groove at top of piston. Stretch boot rearward straightening boot folds, then move
boot forward as necessary until folds snap uniformly into place.
